Print PDF
Favorite
Email
Step 6Etch back of metal tabs/pieces
Like you did with the center if the Rubik's cube centers... Using your choice of a razor blade (Serious... BE CAREFUL!!!) etch the backs of the metal tabs with a 8-way cross-hatch. To do this safely I layed a piece of duct-tape upside down and used two pieces of right-side -up duct tape, and laid the tabs down accordingly, then etched the back with a box-cutter knife with a new blade.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
