Print PDF
Favorite
Email
Step 3Wired
Figure out which wires are going to be used as your audio wires.
The way I did it is by pulling the bottom left wire out of the jack and marking it, then repeating for the one next to it and then again for the one next to that. I then cut off all the other wires.
If you repeat this process for each jack, all the wires will be standardized.
You can also figure this out with a multimeter.
The way I did it is by pulling the bottom left wire out of the jack and marking it, then repeating for the one next to it and then again for the one next to that. I then cut off all the other wires.
If you repeat this process for each jack, all the wires will be standardized.
You can also figure this out with a multimeter.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
