Introduction: DIY Bathroom Renovation

The following instructable is about the renovation of my bathroom.

Step 1: Step 1 - Design the Bathroom

Measure and design the new bathroom layout.

Step 2: Step 2 - Remove the Old Bathroom

Everything from the old bathroom was removed including the floor tiles.

Step 3: Step 3 - Shower and Bath Support Frame

Due to the concrete floor the shower plumbing was run though the wall and the shower bass was raised up by 160mm to allow room for the P trap. The previous shower was in the same sport and was also raised.

Step 4: Step 4 - Sheet the Wall

Use a water proof cement sheet on the wall. full in the gaps with polyurethane sealant.

Step 5: Step 5 - Waterproof

Waterproof all the seams with an appropriate waterproofing agent.

Step 6: Step 6 - Hang Vanity and Mirror

Hang the vanity and mirror as per the manufactures instructions. Extra support timber was added into the frame prior to the cement sheet to support the weight of the wall hanging vanity.

Step 7: Step 7 - Tile, Tile, Tile

Tile everything.

Step 8: Step 8 - Install Shower Frame and Fixings

Install the shower frame and fixings.

Step 9: Step 9 - Take Photos

Take some photo's of the finished product.

Comments

author
AA_Battery made it! (author)2017-07-11

The bathroom looks great! What software did you use for the computer generated images?

author
mickgalt made it! (author)mickgalt2017-07-12

I used both solidworks and sketchup.

sketchup is sufficint enough and it's free

author
AA_Battery made it! (author)AA_Battery2017-07-12

Ok, thank you.

author
MegaBathrooms made it! (author)2017-07-07

Impressive Job

author
MegaBathrooms made it! (author)2017-07-07

Very Impressive Bathroom design and well-executed job!

About This Instructable

716views

18favorites

License:

More by mickgalt:DIY Bathroom RenovationSmall Doll Rocking CotBelt Sander Stand
Add instructable to: