DIY Bubble's Sunglasses From Spooky Tooth (The Adventures of Timmy the Tooth)

Published

Introduction: DIY Bubble's Sunglasses From Spooky Tooth (The Adventures of Timmy the Tooth)

This instructable will show you how to make the sunglasses that's from The Adventures of Timmy the Tooth episode "Spooky Tooth" where Bubbles wore them when Brushbrush and Timmy were heading to the uncommon pyramids.

Step 1: Things You'll Need to Make It

Buy and gather all the items needed for the spooky tooth sunglasses. You will need the following items to create it:

1. ZeroUV Retro Modern Flat Top Mirror Lens Shield Aviator Sunglasses, Pelzer Oversized Color Mirror Flat Top Shield Sunglasses, or Yves Saint Laurent Paris 2337 Shield Sunglasses

2. Eight 5 millimeter hotfix round nailheads

3. E-6000 Glue

4. Toothpick

5. Scotch Tape

Step 2: Gluing the Nailheads

Place eight nailheads on the top part of the lens, use tape to temporarily remove the nailheads after you figure out where they should go, then apply E-6000 glue on the back of the nailheads with a toothpick and place it back on the top of the lens.

Step 3: Preparation for Use

Let the glue dry for about 24 hours or until completely dry and firm.

Share

    Recommendations

    • Stick It! Contest

      Stick It! Contest
    • Backpack Challenge

      Backpack Challenge
    • BBQ Showdown Challenge

      BBQ Showdown Challenge

    2 Discussions

    That is a good question, I've only taken the photo for the intro and we didn't take any pictures of the process because I don't want to be seen on the reflections for privacy reasons. If you and/or someone else has good photos of the process, I'd be happy to add them to this instructable.