Introduction: DIY Chevron Friendship Bracelet

Picture of DIY Chevron Friendship Bracelet

It's time to make a friendship bracelet! The chevron design! My favorite design! If you want to learn how to make a candy stripe design, check out my candy stripe instructable!

Embroidery floss (4 colors)

Step 1: Set Up

Picture of Set Up

Set up your layout like the picture. You don't have to use the same colors set up your colors in order.

Step 2: Knotting Forward

Picture of Knotting Forward

Do all forward knots on the left side. Once you get to the middle stop. Do all forward knots on all, do I twice on each.

Step 3: Knotting on the Right

Picture of Knotting on the Right

Now when your done switch to the right side. DO NOT do forward not. It is pretty much the same thing but a backwards four. Do this twice on each. Until you get to the middle with the left side same color.

Step 4: Middle Knot

Picture of Middle Knot

Once you get to the middle, take the right side sting and do a twice backwards knot on the right, when your done switch strings.

Step 5: Continue and Knot

Picture of Continue and Knot

Then continue those same steps with the others colors. After you have reach your point make a knot.

Step 6: Buttoning and Done

Picture of Buttoning and Done

After you have made the knot take you button and put the strings in the holes and make a knot.

And you are finished!!

Please follow like and comment!!

Step 7: Extra

Picture of Extra

If you want me to show more bracelets to make, comment below!! Please follow and like, also follow me on Instagram! Username: CinCoCaLa08


Princess amirahj (author)2015-11-20

This was helpful thanks

aed13 (author)2014-09-01

Check this out too!!

Rider Girl (author)2014-02-08

Very nice!

Cindy02 (author)2014-01-08

Thanks :D

aqua 12 (author)2014-01-08

Awesome! It looks so cool

About This Instructable




Bio: Follow me in Instagram, which is CindyyNguyyenn
More by Cindy02:Rainbow Loom LadderRainbow Loom Tulip TowerRainbow Loom Triple Single
Add instructable to: