Instructables

DIY Death Star Clock

FeaturedContest Winner

Step 2:

(side note:  if I were to do this again, I would next use my dremel tool and sand away the "emitter / focusing disc" portion as well as dremel in the curved lines -- on this run I did the sanding after I put the foam blocks on and had a few missteps which you'll see on the close up photos below)
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!