With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Some backstory: I recently got a 2.5' millenium falcon gift that I subsequently hung in my office... Well, I got a small wall decal of the death star ...
So to start off with, I resized and printed out an internet photo of the death star. Using the carbon paper, I traced the outlines onto the frisbee.
(side note: if I were to do this again, I would next use my dremel tool and sand away the "emitter / focusing disc" portion as well as ...
Next, I used that same printout photo and traced the outlines onto a sheet of the adhesive backed white foam sheet. Using a scalpel / X-acto knife, I ...
then spray painted the whole thing in semi gloss black (but any black will work I think) - paint was still wet in this image. The textural difference ...
I used a strip of 1/4" tape to mask the center groove / canyon area, then lightly misted some gray primer to highlight some of the areas and ...
I then drilled a small hole for the clock nubbin to stick through and attached the clock arms. Here it is mounted next to my shop clock for ...
total cost: about $38-39 and the final result hanging in my office next to the falcon and TIE fighter:
My Son's Interchangeable Lego Star Wars Clockby YOUgNeek
Death Star Painted Ball Toss Gameby DeandrasCrafts
Death Star Ornament inspired by Star Warsby mstyle183
My Star Wars Death Star Mancaveby Lance70
Levitating Death Starby backwards lamb
Join 2 million + to receive instant DIY inspiration in your inbox.
Download our apps!
© 2016 Autodesk, Inc.