Introduction: DIY Dog Water Alarm

Picture of DIY Dog Water Alarm

welcome this is a very simple project for beginners but also very fun for expert's.

Step 1: Parts

Picture of Parts

You will need some simple parts
1) Arduino
2) Resistor
3) Led or Buzzer
4) A few wire's

Step 2: Build

Picture of Build

The Build Is Easy.
Look through the pictures there is pretty much no explanation needed other than the two contacts in the water cannot touch/short and where ever you place the highest wire and the water gets below it the alarm is going to trip

Step 3: Code

Picture of Code

The code is very simple, you can probably make it yourself but if you can't download it from my site Here

Step 4: Your Done

Picture of Your Done

your dog will be so happy he will fart rainbows + you can make it your own like send you a email or text when the water is low. there are endless possibilities.


seamster (author)2015-05-22

Nicely done. Thanks for sharing this!

About This Instructable




Bio: I like to create new things! I'm very interested in IOT and just Internet Stuff. I am not responsible for any injury or deaths ... More »
More by Funguypro:3D Print Your House!!!!!DIY Raspberry Pi Indoor Outdoor WebcamSee Through Buildings With a Drone
Add instructable to: