Instructables

Step 3:

Picture of
Step Three:
Sand down the holes, removing any loose pieces of wood. This will allow the paint to go on smoother and keep you from getting splinters when using the press. Then make sure that your bolts fit nice and snugly. Test that the nut goes on without falling into the hole you made. If it seems to press into the hole too much you can add washers to counter-act this.
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!