Print PDF
Favorite
Email
Step 2Sizing
Use the knife/razor to score your PCB into two plates that mirror each other. I went with approximately one-square-inch squares, but you could do any two shapes so long as there is copper in between.
Cut your foam into the same shape as the plate.
Solder one wire to each plate. You'll want to make sure the solder is going to hold the wire in place, so clean the copper beforehand if necessary and use plenty of solder.
Cut your foam into the same shape as the plate.
Solder one wire to each plate. You'll want to make sure the solder is going to hold the wire in place, so clean the copper beforehand if necessary and use plenty of solder.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
