Print PDF
Favorite
Email
Step 2Recipe
"Wealth is our organized capability to cope effectively with the environment in sustaining our healthy regeneration and decreasing both the physical and metaphysical restrictions of the forward days of our lives."
-R. Buckminster Fuller
Recipe
make 1/2 tsp of copper, aluminum, zinc (or stainless steel) by cutting approx.1/8 inch pieces of approx. 1/8 inch thick wire. For zinc use ordinary galvanized chainlink fence type wire.
Buy an ordinary economy plastic fuel filter intended for the engine you have in mind. Or use a more expensive metal screw open replacable/cleanable type.
Insert all the beads one by one into the filter through the intake tube. Tap it all down into the canister.
Optional: Break up a neodymium (rare earth) magnet small enough to insert a small piece in with the beads.
Either 1) or 2)
1) Cut a small unpainted piece of aluminum from a beer can to 1/4 inch long and wide as the inside diameter of output tube. make a longitudinal 1/2 twist in it (like a barber pole). Insert tightly into output tube so that no bead can get through. (test this)
2) Cut a 1/4 inch x 1/2 inch approx piece of stainless steel or aluminum mesh with holes smaller than 1/8 inch. Roll or fold it and insert into output tube so as to prevent beads from coming through. Test this.
-R. Buckminster Fuller
Recipe
make 1/2 tsp of copper, aluminum, zinc (or stainless steel) by cutting approx.1/8 inch pieces of approx. 1/8 inch thick wire. For zinc use ordinary galvanized chainlink fence type wire.
Buy an ordinary economy plastic fuel filter intended for the engine you have in mind. Or use a more expensive metal screw open replacable/cleanable type.
Insert all the beads one by one into the filter through the intake tube. Tap it all down into the canister.
Optional: Break up a neodymium (rare earth) magnet small enough to insert a small piece in with the beads.
Either 1) or 2)
1) Cut a small unpainted piece of aluminum from a beer can to 1/4 inch long and wide as the inside diameter of output tube. make a longitudinal 1/2 twist in it (like a barber pole). Insert tightly into output tube so that no bead can get through. (test this)
2) Cut a 1/4 inch x 1/2 inch approx piece of stainless steel or aluminum mesh with holes smaller than 1/8 inch. Roll or fold it and insert into output tube so as to prevent beads from coming through. Test this.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
