Introduction: Head-shot Wounded Lego Minifigure
In this instructable, we will be making a DIY head-shot killed lego minifigure. We will take a nail, heat it up, stick it through the minifigure's head. Then we will apply some fake blood to it. Excuse me for my bad camera quality (Not this picture, the other pictures in the other steps) I used a GoPro instead of my DLSR camera for taking pictures of the steps, while I used my DLSR camera only for the final photos. I should have used the DLSR camera for everything. I wasn't really thinking. Enjoy.
Adult supervision is advised if under 18 years old.
PLEASE NOTE: I am not responsible if you injure yourself during this project. Be careful.
Here is a preview of the result:
Step 1: Materials
For this project you are going to need:
- A multitool
- A nail (your size choice, just the hole will be a little bigger than the nail)
- Small nail (smaller than the other nail)
- Lego minfigure
- Fake blood
Step 2: The Nail and Head
Ok, now it's time to heat up the nail. MAKE SURE YOUR OUTSIDE OR INSIDE A HEAVILY VENTILATED AREA. BE CAREFUL!
- Hold the nail with the multitool
- Heat up the nail until it's color changes to faint red
- Now quickly stick the nail through the head (make sure your outside or inside a heavily ventilated area with fans)
- Let the minifigure cool down
Step 3: Fake Blood
Now when you're lego minifigure has cooled down, you're going to add some fake blood to it. Add a little bit of fake scar blood to a cotton-tipped applicator, then add some to your minifigure.
Step 4: Blood in the Inside
Next, you're going to dip a small nail (smaller than the nail you used before) into fake scar blood. Then slide it through the head of the minifigure.
Step 5: Finalizing
Ok, were almost done. If you want, add some fake drippy blood to the head to make it seem real.
Step 6: Done
Congratulations! You are done with your DIY head-shot killed lego minifigure! Stay tuned for more cool Instructables.
We have a be nice policy.
Please be positive and constructive.