DIY High-Speed Book Scanner from Trash and Cheap Cameras

FeaturedContest Winner

Step 62: Handle/Electronics: Momentary Switch Installation 1

Picture of Handle/Electronics: Momentary Switch Installation 1
Now we need to take a break from the hub and work on a switch. You need to get the rest of your flashlight disassembled.

This flashlight is just press-fit together. You can pop the LEDs out of the front with pressure from a screwdriver. You can pop the switch from the tailcap by carefully applying lots of pressure to the switch. We will not be using the switch(because it is a "push-on, push off" type), so don't be too worried about destroying it if you have to. Remove the switch from the black plastic tailcap piece. Leave the rubber cover in place.
Remove these adsRemove these ads by Signing Up