Instructables

DIY High-Speed Book Scanner from Trash and Cheap Cameras

FeaturedContest Winner

Step 65: Handle/Electronics: Momentary Switch Wiring 2

Picture of Handle/Electronics: Momentary Switch Wiring 2
HANDLES_0010_Layer 4.jpg
HANDLES_0008_Layer 6.jpg
HANDLES_0007_Layer 7.jpg
Solder the wires from the switch to the coil cord wires. The order is not important.

I used heat shrink tubing to keep things nice and clean.

Heat the heatshrink to shrink it.

Apply liberal amounts of hot glue to the incoming coil cord to fix it in place.
 
Remove these adsRemove these ads by Signing Up