Print PDF
Favorite
Email
Step 5Finishing Up The Board Assembly
Once the board is fully assembled, you can now apply power leads to the power input terminals. We have seen these units mounted in many different types of housing, including PCV plumbing end caps.
When you power up your system, you may notice a slight glow to the LEDs. This is common on 850nm models where you will see a slight red glow to them. The 940nm models do not have any glow that is visible to the human eye.
Good luck with your build and you are sure to receive many years of service from your IR Illuminator display.
When you power up your system, you may notice a slight glow to the LEDs. This is common on 850nm models where you will see a slight red glow to them. The 940nm models do not have any glow that is visible to the human eye.
Good luck with your build and you are sure to receive many years of service from your IR Illuminator display.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
