Introduction: DIY Micro Amplifier

this is just a simple diagram of how to make a amplifier and pins

comment for more projects :P

parts:

1. lm386

2.wire

3.9-volt battery and connector

4.speaker

5.10k ohm resistor (1/4 watt)

5.220 mf cap. (10.volt)

6.3.5mm audio jack

7. an afternoon :P

tools needed:

1.soldering equipment

2.helping hands (u can do it without it just makes the job alot more easy)

Comments

author
marc.deloor.5 (author)2016-01-01

Nice start :-)

Next step: using a resistor or variable resistor to adjust the gain of it. (using the gain-pin):-)

Oh, and try to change the capacitors, so you can improve the bandwidth of the amplifier :-)

About This Instructable

891views

31favorites

License:

Bio: i am 13 years old i love DIY,PC,GAMING,electronics,engines,soldering,fireworks
More by Jens Victor:DIY micro amplifier
Add instructable to: