1 brass door hinge post (~3 inches long)
6 small washers that fit on the post (~half inch wide)
5 thin large washers that fit on the post (~1 inch wide)
1 cork, cut in half
1 drill, to drill hole slightly smaller than hinge post in cork halves
1 ink pad
Plastic container to store the stamp (otherwise it gets messy)
Watch the video for building instructions. I tried rubber washers and the ink sticks better, but the lines were too blurry and they were too flimsy. I tried smaller washers but they were too small for the cork. So far, the large metal washers work best.