Step 3: Encapsulate the cells
Then put some tile spacers. I used 3/8" spacers. I put them so that any direct pressure on the cover doesnt crack the cells.
Follow these steps:
1. Place silicone at the back of the cells and stick them to Acrylic sheet.
2. Place tile spacers.
3. Put generous dose of silicone at the edge of the acrylic sheet. Then take the upper sheet and stick over the cells.
Thats it! Let the silicone dry and the panel is ready .
Each cell produces about 2V and in the best case up to 3A of current. (6W of power).