Introduction: DIY Pot Generator, 9 TEG Modules Test With 10W LED Chip

Picture of DIY Pot Generator, 9 TEG Modules Test With 10W LED Chip

Watch the video to see it in action!

TEG model: SP1848-27145 SA

Step 1: How It's Done..

Picture of How It's Done..

Connect the modules in series.

Put some heatsink paste on the cold side.

Put them on the water pot as the picture.

Glue them with some thermal silicone (NOT ON THE SURFACE) and wait until it dries.

Put a sensor in the center for the temperature.

Put some heatsink paste on the hot side.

Now put some thermal silicone on the spaces between the modules and put the whole thing on the other pot (hot side pot / aluminum sheet).

Now you can test it with a voltmeter and its temperature sensor!

Happy generating!

Comments

About This Instructable

1,227views

9favorites

License:

More by Rajaa Kahel:3D Printed Actual SpeakerDIY Portable Generator 3-In-One (Electricity From Heat)DIY Magnetic Jack/Plug For Any Purpose (No Soldering)
Add instructable to: