Print PDF
Favorite
Email
Step 2Getting the Pokemon Pinball board to fit
I cut the board with a junior hacksaw and then drilled the 2 holes for the plastic PCB supports tracing the outline of the original PCB.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Jul 20, 2007. 8:48 AMSatype
says:
Was there a problem with using the rumble motor from the pinball cartridge?
Reply
2
Jul 20, 2007. 10:49 AMXyzzy (author)
says:
Unfortunately the motor from the Pokemon Pinball was too large....The one from the Nokia phone is tiny...
Reply
8
Jul 23, 2007. 4:48 PMPunkguyta
says:
Xyzzy? From the recently brought down WD Forums?..Sonofagun
Reply
2
Jul 27, 2007. 11:46 AMXyzzy (author)
says:
WD Forums? Sorry not me, I chose Xyzzy because my activation code from instructables was being blocked as spam. I ran out of usernames and email addresses and eventyally used this out of frustration...which was the only one which wasn't filtered out....go figure.
Reply
8
Jul 27, 2007. 12:07 PMPunkguyta
says:
Oh, well that's quite the coin-cidence, why didn't you just add a rule to your spam filter to allow bot@instructables.com?
Reply
 |
Add Comment
|
