Print PDF
Favorite
Email
Step 5Attach flanges to board
Drill holes in both boards to accomodate the bolts. I used a boring bit to sink the bolt heads and washers on the floor board. Attach a flange to the floor board, but NOT TO THE CEILING BOARD. The order should be(bottom to top): Bolt, washer, board, flange, washer, nut.
Attach your no-skid solution to the bottom of the floor board.
It was at this point that I realized the bath tub strips sucked. I went to the grocery store (it's now 9ish pm) to see if they had any jar openers. They didn't have the flat ones I wanted, so I got the rounded ones you see.
I split the jar openers, and superglued them on.
Attach your no-skid solution to the bottom of the floor board.
It was at this point that I realized the bath tub strips sucked. I went to the grocery store (it's now 9ish pm) to see if they had any jar openers. They didn't have the flat ones I wanted, so I got the rounded ones you see.
I split the jar openers, and superglued them on.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
