Introduction: DIY Table Mono-pod With HARD DISK

Picture of DIY Table Mono-pod With HARD DISK


Hi everyone I'm back with a simple DIY Table Mono-pod for camcorder and camera.
You will need :
 - Used hard disk
 - Thread Aluminum tube
 - Srew x2

So it's simple just open the hard disk and empty it. Keep the chassis and the cover. Drill the cover and screw it up to the aluminum tube.
Screw up the other side to the camcorder
and done !



Comments

zazenergy (author)2011-03-17

That's pretty cool! Is it fairly stable?

miika191 (author)zazenergy2011-03-17

It's really stable, because the hard-disk is very flat. I think I'll put wheels^^

About This Instructable

1,227views

4favorites

License:

More by miika191:Diy Steadycam with halogen lightDIY Table Mono-pod with HARD DISKCamcorder On Water Boat
Add instructable to: