Instructables
loading
loading
Picture of DIY Tripod Made Out of PIpe Cleaners
104_0212.JPG
104_0213.JPG
How to make a tripod for a camera with some pipe cleaners. This is my first Instructable, so bear with me
 
Remove these adsRemove these ads by Signing Up

Step 1: What you Will Need

Picture of What you Will Need
FWXDGFIF0ZSTF1P.MEDIUM.jpg
All you will need is:

1x 1/4in. -20 Threaded Hook
About 30 Pipe Cleaners
1x Camera (Duh)

Step 2: Twist the Pipe Cleaners Together

Picture of Twist the Pipe Cleaners Together
104_0166.JPG
Twist about 10 Pipe Cleaners together, depends on the weight of your camera. Add more if your camera weighs a lot.

Step 3: Fold In half

Picture of Fold In half
104_0174.JPG
104_0175.JPG
Then fold the twisted pipe cleaners in half and wrap one more pipe cleaner around it to keep it folded. Make sure you leave a loop at the end (See second picture if you're confused) After you're done, repeat it twice more.

Step 4: Test it!

Picture of Test it!
You may want to put a pipe cleaner through the loops to test it, or add some rings to ensure it's strength.

Step 5: Use it!

Picture of Use it!
If you are satisfied with the test, take the top pipe cleaner out that is holding them together (The purple one in my case) and put the hook through the loops. You may want to glue the connection, I just wrapped a few pipe cleaners around the it. Then just screw it into the tripod screw spot.
mikamb5 years ago
good idea.  even works on uneven surfaces.
amazing..PEIRIOD
ChrysN5 years ago
That is pretty cool, I am surprised at how sturdy it is!