Introduction: DIY Vintja Keyhole Charm Bracelet

About: Diy'er, jewelry designer, woodworker, blogger. Come visit me at Http://mixedkreations.com/blog

Easy charm bracelet for beginners.

Step 1: Tools Needed

To make a bracelet like this one you will need a pair of round nose pliers, and two curved chain nose pliers.

Step 2: Supplies

Vintja keyhole
Antique brass lobster clasp
Key charm
Heart charm
Freshwater pearl
Antique brass headpin
3 Jumprings
Two sizes of chain- (3 pieces of small chain 3 3/4", and one larger chain 2 1/4") These lengths added to my keyhole, clasp, and jumprings will fit up to a 8" wrist.

Step 3: Connecting Larger Chain


First take your headpin with pearl and make a wire wrapped loop on one end.

Take one jumpring, larger chain, key charm, wire wrapped pearl, and connect to one side of vintja keyhole.

Step 4: Connecting the Three Chains

Now take your three smaller pieces of chain and connect them to the other side of your keyhole with a jumpring.

Step 5: Adding Your Clasp

Use a jumpring to add your lobster clasp, and heart charm to the other end of your three smaller pieces of chain.

That's all there is to it. Wasn't that easy?