DIY Vivus the Robot

Step 3: Power to Microcontroller

 Attack the power clip’s wires to the microcontroller so that the black wire goes into the left slot in the bottom right and corner and the red goes in the slot to the left of the black wire. Screw down the screws so that the wires are held in place. Keep in mind that the microcontroller comes preprogrammed, so you don't have to write any code yourself.

NOTE: you may have received a different type of battery holder, where the wires are built into the box. This works just as well, but you many want to wait until the end to screw in the black and red wires.