Introduction: DIY Breadboard Power Supply

Picture of DIY Breadboard Power Supply

In this project I´m making an 5v and 12v power supply for the Radioshack breadboard. his

Step 1: Parts

Picture of Parts

The parts I used for this project is:

* 5v to 12v step up

* Wires

* Small project box

* 4 male pins

* PCB

* Breadboard

* 4x battery holder / USB cable

Step 2: Make It Fit

Picture of Make It Fit

My 5-12v step up did not fit in the box I have so I had to cut off the wire connectors and solder the wires to the board instead of screwing them to it.

Step 3: The Power Connectors

Picture of The Power Connectors

Solder two male headers to an 2x2 PCB and than the + and - cable to the pins, do that to both cables.

Step 4: The Box

Picture of The Box

Make two holes one one side of the box and one on the other side, the holes have to be big inouf for the cables.

Step 5: Soldering

Picture of Soldering

Take 6 wires and solder 4 to the input and 2 to the output.

Step 6: Mounting

Picture of Mounting

Screw the two input wires to + and - on the breadboard connectors, and connect 5v to the red and black connectors.

THANKS FOR WATCHING

iIIf you have any questions please ask in the comments and share a photo if you make it :)

Comments

About This Instructable

1,878views

21favorites

License:

Bio: I am always making electronic stuff. I like to do Arduino projects best. more projects coming soon!
More by ibenkos:433MHz 4Ch Remote ControllerWireless Robotic Control Hack a servo
Add instructable to: