Introduction: DIY (ceiling Stand) Flashlight

Picture of DIY (ceiling Stand) Flashlight

With a single rare-earth (neodymium) circular magnet, I could make the flashlight stick to any metal surface.

I'm positive the magnet will NOT damage your flashlight.

Items used:

  • 1/43 diameter x 1/103 thick circular magnet (fit perfectly inside the LD01 tail)
  • Super glue (be careful once you glue, it sticks forever)
  • Fenix LD01 flashlight

Step 1: Glue the Magnet

Picture of Glue the Magnet

Remember, once you glue the magnet, it will be stuck really hard to the flashlight.

Using any kind of super-glue, glue the magnet inside the flashlight tail (I used 1/43 diameter x 1/103 thick magnet), I bought these magnet at Lee Valley store.

Step 2: Testing Out

Picture of Testing Out

After few sec, you can give it a try to any metal surface.

Visit my site as well if you like this idea. Thanks


MACKattacksnipe (author)2010-08-17

Good idea for the power outs just stick it too the ceiling

lilpepsikraker (author)2009-09-13

I have LD01!!!!! I love it so much, I bought another.

About This Instructable




More by thuyla:Fisher Space Pen for Key Chain (mod)Paracord 4-Peg Spool KnittingDIY (ceiling stand) flashlight
Add instructable to: