Step 10: On/Off Switch
Glue small strip to large strip (the rails)
Solder wires to paperclips
Solder 1 magnet to 1 of the paperclips
Staple paperclips to wood.
Add magnets to paperclip with soldered magnet until they "catch" the other paperclip when turned on.
This will be the connection between pin 13 on the Arduino and the LEDs, when this is off the LEDs will not light up.
Solder wires to paperclips
Solder 1 magnet to 1 of the paperclips
Staple paperclips to wood.
Add magnets to paperclip with soldered magnet until they "catch" the other paperclip when turned on.
This will be the connection between pin 13 on the Arduino and the LEDs, when this is off the LEDs will not light up.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
