Print PDF
Favorite
Email
Step 2Make the disks
Your plastic disks need to be a few millimeters larger in diameter than the base of your suction cup... but not too large because then it's harder to stick on your curvy dash.
Mark your circles on the side you won't be suctioning (the rougher side of the plastic).
I used a cup that happened to be slightly larger than my suction cup base (I could barely stick that sucker in the cup) with tape around the edges in order to mark my circles with my marker. Richer people can use that thing that helps you draw circles (protractor??)
Cut out your circles with scissors. Perfectionists can also file down the rough edges of the plastic.
Mark your circles on the side you won't be suctioning (the rougher side of the plastic).
I used a cup that happened to be slightly larger than my suction cup base (I could barely stick that sucker in the cup) with tape around the edges in order to mark my circles with my marker. Richer people can use that thing that helps you draw circles (protractor??)
Cut out your circles with scissors. Perfectionists can also file down the rough edges of the plastic.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
