Instructables

Modelling a Raspberry Pi case - from Cardboard

Featured

Step 6: Light Pipes

Picture of Light Pipes
6 c Score and Snap.jpg
6 b Light Pipe.jpg
Now that the grill is made, cut the holes for the light pipes.

Next take some clear plastic sheet (about 2mm thick) and cut into the sizes as shown. This may require some fiddly cutting and snapping with pliers as shown - please check out this video if you have not done this before, here.

As shown in the final picture - check to see that the light is transmitted effectively, by hovering it over the PCB.
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!