Introduction: Designer Cardboard Cube

This is a design exercise I completed many years ago. It is made with cardboard, glue, and spray paint. Although the surfaces are very durable due the layers of spray paint, there were an excessive number of blades used to complete the job. The blades were quickly worn out after cutting through so much spray paint.

INSTRUCTIONS: Design in one plane then extrude. Make permeable areas continuous and intersect passages. Use intersections to make the structure rigid.

Step 1: Start Flat

Design in one plane then extrude

Step 2: Intersect Extrusions

Make permeable areas continuous and intersect passages

Step 3: Structural Soundness

Use intersections to make the structure rigid

Comments

author
seamster made it!(author)2016-09-02

This is a pretty amazing sculpture. Thanks for sharing :)

author
cathgates made it!(author)2016-09-02

Thanks seamster! I'm impressed with your Instructables about tennis balls and decks of cards. cg:)

About This Instructable

106views

0favorites

License:

More by cathgates:Designer Cardboard Cube
Add instructable to: