With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
i was thinking instead of my phone just lying on my desk / PC Station ,I can make a stand to prop my phone up , so away i ...
cutting from the 24" x 24" sheet of ABS on a mini band saw
rounded all the edges , 12" x 3" planer sandpaper (self adhesive) on the bench to keep a long sanding stroke
using the torch on a low flame , gently moving back and forth .
to heat about an inch from the edge, when it starts to warp place the edge on the bench and hold it down till it hardens ,(i had ...
on the smooth side of the ABS i lightly sanded down , was too glossy ,............Here i made some marks to direct the flame for the next bend ...
roughly about 3 3/4 inches from bend to bend , lying on its side to cool and holding the desired angle , and also keep the frame edges ...
here i cut off the excess i use a rt angle pick or Razor knife to score the ABS and a ruler or something that has a true squared ...
here i set flat on the bench for its standing position ,
and on its side to make sure the sides were flush with the flat surface , and let it cool off in the fan
instead of leaving a big flat surface on the back i cut out a hole with the dremel , and filed down the edges , i didnt like ...
i wet sanded the back to take out the sanding swirls , since it was raining ,and i had free water ,lol
my flash on my camera took a Dive , i was using my Current phone HTCG2 to take pictures i had this one for test pics ,
measuring to cut the liner
i used the rubber glue to hold down the liner , this is strong stuff , much like the gorilla glue but stronger and cost more , you ...
front & bottom surface w/ liner attached
this one i curved the edges for one of my sisters HTC Mytouch will keep it straight up ,
Join 2 million + to receive instant DIY inspiration in your inbox.
Download our apps!
© 2016 Autodesk, Inc.