Print PDF
Favorite
Email
Step 2Assembling the ramp
The base of the ramp is made by connecting the two cross pieces with the two side pieces and using some hot glue to keep it strong.
For the ramp piece itself, I used an X-acto to slice lines across the back so that the front would have a smoother curve to it. After this was done I used the body of the X-acto as a guide for the curvature of the ramp.
For the ramp piece itself, I used an X-acto to slice lines across the back so that the front would have a smoother curve to it. After this was done I used the body of the X-acto as a guide for the curvature of the ramp.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
