Print PDF
Favorite
Email
Step 2Make the Connection...
Remove the 5 small screws that hold the case top cover on.
There is a 5-pin connector located between the power supply and the main board. Directly next to the connector on the power supply you will see two small jumpers. This is where to make the solder connections for the Positive (+) and Negative (-) wires. Use a multimeter to confirm this location with the unit plugged in and you should get a reading of 12VDC. I attached two wires (red (+) and black (-) about 4 inches long.
There is a 5-pin connector located between the power supply and the main board. Directly next to the connector on the power supply you will see two small jumpers. This is where to make the solder connections for the Positive (+) and Negative (-) wires. Use a multimeter to confirm this location with the unit plugged in and you should get a reading of 12VDC. I attached two wires (red (+) and black (-) about 4 inches long.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
