Introduction: Don't Go Bacon My Heart
This box contains 2 separate containers and a lid. The lid does not latch in place so be careful with what you put inside. Note: I did scale my design down to 40% so it could fit on my printer.
You will need:
- Glue gun
- 3D printer
- Box design:
Step 1: Printing
1. Use the provided file to print out the box heart
Step 2: Assembling
2. Conect the lid to the heart shaped box and insert the rod into the joints.
Step 3: Glueing
3. Take the hot glue gun and put a glob of hot glue on each end of the pin to secure from sliding out of the joints.
We have a be nice policy.
Please be positive and constructive.