Print PDF
Favorite
Email
Step 12Fiddle with the layers a bit
It can be helpful to turn on the "pins" layers so you can see exactly
where you are supposed to make connections on the various componenets.
where you are supposed to make connections on the various componenets.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
2
Oct 11, 2006. 5:33 PMpfred1
says:
I got to check out layers in schematic mode. I use layers a lot in the board layout part, not so much in the schematic part. I have a heck of a time getting the wires to actually connect in schematic mode. Lots of times I have to move the part and ram it into my wires in order to get a connection, then Eagle gives me a dot and I have to move the part again, and delete the extra wire stub.
Reply
 |
Add Comment
|
