Print PDF
Favorite
Email
Step 3Finishing the Pants
Put a tiny breadboard into a small box (I used a servo box) and create a pull-down circuit to connect to each FSR. Place this box in the left jean pocket.
Then, create a 4-pin female connector with the following pins:
1. 5V power
2. Ground
3. Left Knee Input
4. Right Knee Input
Also, create a moderately long 4-pin male connector that will eventually be used to connect the female connector on the pants to the Arduino. Both male and female connectors can be made by soldering four wires to the connector, and then insulating each lead from the adjacent leads with electrical tape.
Then, create a 4-pin female connector with the following pins:
1. 5V power
2. Ground
3. Left Knee Input
4. Right Knee Input
Also, create a moderately long 4-pin male connector that will eventually be used to connect the female connector on the pants to the Arduino. Both male and female connectors can be made by soldering four wires to the connector, and then insulating each lead from the adjacent leads with electrical tape.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
