Introduction: EARTHQUAKE ALARM Using the KY-002

Picture of EARTHQUAKE ALARM Using the KY-002

Hello peoples! Here i am again.

This time i made a Basic earthquake alarm with the KY-002 Shock sensor.

Its can be used for multiple purposes, Like most sensors. In this case we use it as a earthquake sensor.

Check the following step for Schematic and code.

Step 1: Schematic Code & Parts List.

Picture of Schematic Code & Parts List.

Parts list:

  1. Arduino uno, I used the RobotDyn uno, a chinese copy with 7 analog pins. VERY GOOD!
  2. Shock sensor Ky-002
  3. 3 Color RGB Led ky-016
  4. Buzzer
  5. SET of Jumper wires. MM FF FM

Good Luck building it. Its done in a few minutes!



About This Instructable




Bio: Hello world! I make simple & Advanced projects for people who want to learn programming and electronics. Most of my Instructables are about arduino and the ... More »
More by vandenbrande:ARDUINO - SOLID STATE RELAY FAN/ventilator Control Using the W1209 Thermistor and SSR-25 DA Arduino - SSR-25 DA Solid State Relay and DS3231 RTC Automatic Timer Lamp Arduino & C# - RGB LED / LED STRIP CONTROL C# Application
Add instructable to: