I then went to the equal of the "dollar store," and bought 2 3'rd hands. This is the end result a really nice 3'rd hand!
Step 1: What you need
3 mm. ID hot shrink tubing
Heatsource eg. lighter / soldering iron
Step 2: Disassembly
1 - Screw off the crocodile clip, on the opposit side of the magnifying glass, on A (pic 1)
2 - Screw off the crocodile clip, on the same side as the magnifying glass, on B. (I forgot to take a picture)
3 - Screw off the magnifying glass, on B. (I forgot to take a picture)
Step 3: Re-assembly
2 - Slide the 3'rd crocodile clip on A. (pic 3)
3 - Attach the crocodile clip, you took of A earlier, to A (pic 4)
Now you just need to add your hot shrink tubing to the crocodile clip tips.
Step 4: Hot shrink tubing
You will need some 3 mm. ID hot shrink tubing, cut to pieces about 3 cm. long (pic 1)
1 - Put the pieces over the tips if the crocodile clips, and heat them. (pic 2 & 3)
2 - Add an extra layer of tubing, and cut it off. Leave about 0,5 mm. of tubing. (pic 4)
Step 5: Finished!
Step 6: Left over parts
It does make a great nerdy picture holder though :-)