Step 1: Materials
3. Liquid Nails
4. 2 90degree Metal Corner Brackets
5. 1 1" screw
7. Metal Hanger
9. Soldering Iron and Solder
10. Belt buckle compatible belt.
Step 2: Remove Cord From NES Controller
Use scissors to cut the cord out of it from where it connects to circuit board.
Step 3: Cut the bottom section off of the hanger
Step 4: Use plyers to bend the cut section into a square
Make it on average 1 1/2" On each side, but belts are different. Make it fit yours.
Step 5: Use soldering iron and solder to make the ends of the wire connected.
Step 7: Use drill to drill hole and insert screw.
Step 8: Get 2 corner brackets (90 degree pieces of metal with a screw/bolt hole on each side).
Step 9: Put the 2 flattened brackets on the NES with the wire underneathe
Step 10: Wait for it to dry.
PLAYLIST OF CHOICE:
1. Senses Fail
4. The Pillows
5. Rise Against
Yeah.. jam out dawg. You earned it.