Intro: Monkeylectric Model 132s Installation Instructions
This Instructable shows how to attach a 'Monkeylectric M132S' to any type of bike wheel, with many examplesRegister your m132s! If you purchased from...
- insert 3 batteries and check that the device works before you attach to the wheel!- Press the POWER button to turn on or off the device, and change ...
- device is mounted inside the wheel, between the two layers of spokes (for all standard wheels)- line up the two "A" mounting areas over a single spo...
Step 6: Attach the third mount point ("B"), also loosely
This step can be a little tricky depending on your wheel. - place the 3rd spacer between the device and the spoke, line it up to whichever mounting s...
- Squeeze the spoke and device together while you are tightening to squish the rubber a bit, this helps to get it tight. - Tighten the "A" mount poin...
- the zip-ties should be tight enough to squish the rubber a bit like in the photo. this is important for keeping the device in place while you ride....
The spokes were so close together that we could not get the device inside We mounted the device on one side of the wheel, on the outside. Since it i...
Step 16: Example: mounting close to the hub - for high speeds
You might prefer mounting the device close to the hub, it will improve bike handling especially at high speeds. Shown on a standard 36-spoke road bik...
Step 15: Example: 24-spoke fancy Mountain Bike wheel, rear
Bio:Dan Goldwater is a co-founder of Instructables. Currently he operates MonkeyLectric where he develops revolutionary bike lighting products. He also writes a DIY column for Momentum magazine.
More by dan
Stats
Total Views
10,374
Views Today
0
Comments
3
Favorites
2
Get More Out of Instructables
Already have an Account?
PDF Downloads As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.