Earring Tree

I have tried to find a decent earring tree for my daughter this Christmas, but could not find any that she would like. So I decided to make my own for her. I had some left over Sintra from my samurai costume that i made, so I decided to use that material. (the costume is on here!)  I did not take as many pictures as I like because I forgot to take them at certain steps, but you will get the idea.

Step 1 Rough Cut

At first, i had to come up with an image that I could use to trace the pattern onto the Sintra. Once I found the image, I printed it our and traced it onto the plastic. I used my handy dremel to do a rough cut around the figure. The picture quality was not that good, but you get the idea.

Comments

[elliespaghetti]

Great idea. I'm going to make one with a hand rather than the person. That way I can store some rings also.

[jrossetti]

using a wire screen like that is a great idea.  I think I'll follow your instructable to build one for my wife.