Earring Tree

Step 3 Base and angle piece

I did not get pictures of the base, but I did a few diagrams to show how I did it. I cut 3 identical pieces to make the base of the earring holder.  I had a couple HUGE washers that were heavy enough to give it some weight. I did not want an earring tree that would fall over easy! Sintra happens to also be a thermoplastic. So I was able to heat a strip in boiling water and form it to an angle. this angled piece would connect the base to the earring tree.

So I apologize for not having the actual pics, but i tried to accommodate with my mad MSPAINT skillz!