Instructables

Easy Cassette USB flash drive

Picture of Easy Cassette USB flash drive
L1070651.JPG
What you need:

- An unwanted cassette 
- A USB flash drive
- Sandpaper or a file
- Either tape, blu tack or glue
- Marker
 
Remove these adsRemove these ads by Signing Up

Step 1: Open the cassette

Picture of Open the cassette
Open up the cassette and take out all the parts.
Open the USB flash drive and save the circuit bit.

Step 2:

Picture of
Put the two cassette shell pieces back together and mark where to make the hole for the USB flash drive.

Step 3: Sand or File

Picture of Sand or File
L1070655.JPG
Use the sandpaper or a file to sand down the marked area for the hole.
Check to make sure the flash drive will fit.

Step 4: Stick the USB flash drive down.

Picture of Stick the USB flash drive down.
Once you have a big enough hole, use either glue, tape or blu tack to stick down the circuit of the flash drive on the inside on one of the tape sides, so the silver part sticks out of the side.

Step 5: Put the tape pieces together

Picture of Put the tape pieces together
Put the tape pieces back together and glue if you like. 

Step 6: Finished!

Picture of Finished!
Done! A cassette tape USB flash drive - the case also doubles as a stand.