Hi everyone.
This is my 1ST instructable so please be easy with your comments.
In this instructable I'm gonna show how to make an EASY FAST DC MOTOR.

Step 1: Gather Your Materials

You will need:
1. 1x 1.5 meter enamelled copper wire
2. 2x Bicycle rubber bands
3. 1x 1.5 volts battery cell
4. 2x Magnets
5. 2x Safety pins

Step 2: Make the Coil

1. Make the wire into a coil using the D sized battery & remove it from the cell.
2.Tie the coil diametrically outwards as shown.
3. Scrape the enamel fully form one side & on the other side only 3 sides as shown.
4. Now the coil is ready.

Step 3: Assembly

Assemble the parts as shown in picture.

Step 4: Enjoy !!!!

Enjoy the 4 steps EASY FAST DC MOTOR!!

NOTE : Place another magnet above the coil for more speed. 
<p>I made some slight design modifications. Used 1.5m of 24 gauge wire wrapped into a 1-inch diameter loop with a 1/2 inch by 1/8 inch N48 neodymium magnet and a AA battery. It worked really well.</p>
Didn't some 15yo post this a few weeks ago?
i dont know...
wanted to do something like this for my kid. your setup is very easy. great <br>
thnks <br>

About This Instructable




More by kishore136:Magnetic Torch Easy FAST DC MOTOR 
Add instructable to: