Step 2: Getting Started

Ok so we have all the materials it's time to start the build.

Firstly cut a strip of duct tape that is a bit longer in width of the bag, a few centimetres on both sides.

Lay the top most edge of the bag on the top edge of the tape (sticky side up) leaving a bit of space either side where the tape over hangs.

Fold the flaps that over hang onto the other side and pat down to form a good seal.

Cut another strip similar length and lay it downplace the bag over it again so the new tape overlaps the old by about a centimetreand pat down.

fold over the over hang and pressdown to seal.

you can continue this process until you are satisfied with the size of the bag or you run out of bag length.

For me I only wanted a small bag so I only repeated this step 3 times
This is So Creative<br>

About This Instructable




More by elyas22:Easy Simple Duct tape pencil case 
Add instructable to: