Introduction: Easy IPod Touch Charger Dock

Picture of Easy IPod Touch Charger Dock

Materials- 7 2x2 thick blocks 1 2x4 thick block 2 1x6 thick blocks 1 1x12 thin block 2 2x4 rounded thick block 2 2x6 thin blocks 2 2x4 thick slanted blocks 1 2x6 thick block Supplies- IPod Charger Optional- 2 1x1 dot piece

Step 1: Base

Picture of Base

First you want to get the 8x8 thin piece and snap on the 2 2x2 pieces in the front like so.

Step 2: Front

Picture of Front

Add the 2x6 piece on top of the two 2x2 pieces with the rounded 2x8 piece.

Step 3: Sides

Picture of Sides

Snap on the four 2x2 blocks on the edge like so add the slanted ones on top of them

Step 4: Back

Picture of Back

Add the 2x6 block at the back of the contraption, then add the two 2x4 blocks on top. Last put the rounded piece on top.

Step 5: Balance

Picture of Balance

Get the rest of the pieces except the 1x12 piece and place them on the front like in the pictures for balance.

Step 6: Inserting the Charger

Picture of Inserting the Charger

Turn the contraption on its side like in the pictures insert the charger into the little slot like shown in the pictures.

Step 7: Finishing Up

Picture of Finishing Up

Last of all add your iPod on the dock, it's ready to charge, play music or just sit there

Step 8:


tagglisson99 (author)2013-04-30

Thanks, I kinda made it up as I was going. :)

Penolopy Bulnick (author)2013-04-30

Nice design :)

About This Instructable




More by tagglisson99:Best Baked ApplesHow To Play I've Got A Feeling- Black Eyed Peas On Guitar Easy iPod Touch Charger Dock
Add instructable to: