Print PDF
Favorite
Email
Step 2Enter the specifications
Solidworks comes with with this handy feature called a design table. It is an excel spread sheet which can, and in this case does, contain a bunch of equations that drive the design. So, open the spreadsheet - either in excel or in solidworks - and in the yellow hightlighed area, enter in the pertinent parameters: desired force, throw, lateral clearance, and magnet strength/geometry.
You will have to manipulate the gap height parameter to find the gap height that gives the best flux density (least power) while not exceeding whatever spatial limitations you might have. As you play with this, you will not that the equations break if you choose this parameter unusually low or high.
You will have to manipulate the gap height parameter to find the gap height that gives the best flux density (least power) while not exceeding whatever spatial limitations you might have. As you play with this, you will not that the equations break if you choose this parameter unusually low or high.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
