Print PDF
Favorite
Email
Step 4Modify Male Header : Pivot
So the wires now have a shift in them, but they're at a cock-eyed angle. To fix this, give them a push with a soldering iron.
Touch a wire with the iron, and in a few seconds the plastic around it will melt. At this point you can pivot the wire so it's perpendicular to the plastic again. It may be a little off after the first push, but that's ok. You can reheat the wire and move it as many times as needed until it's in the right place.
Touch a wire with the iron, and in a few seconds the plastic around it will melt. At this point you can pivot the wire so it's perpendicular to the plastic again. It may be a little off after the first push, but that's ok. You can reheat the wire and move it as many times as needed until it's in the right place.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
