Introduction: Embossing Finish

By

Make embossing.

Step 1: Make Data of the 3D Modeling

Data is made by a Rhinoceras.

Attachments

Step 2: Use the 3D Printer

Step 3: Output

Output it one by one.

Step 4: Put Together

Put two together.

Step 5: Make a Data

Data is made by an illustrator.

Attachments

Step 6: Laser-cutting

The material 3 millimeters of acrylic board.

It cut in a laser cutter.

Step 7: Traial Push

Step 8: Finally

Stick emboss on 3D modeling.

Use the double-stick tape.

Finished!!